The GE Fanuc IC693MAR590 is a 120 volt AC Input/Relay Output
module. Equipped with eight input points, this module is designed
to work with the Series 90-30 Programmable Logic Controller. The
eight input points share a common power input terminal and it also
has eight normally-open relay circuits. The input circuits are
grouped together but the output points are split in two groups of
four. Each output group has a common power output terminal. The
module can operate pushbuttons, electronic proximity switches and
limit switches due to its input characteristics. The user just
needs to supply an external AC power source.
Each open relay circuit has an output switching capacity of 2 amps.
These outputs may be used to control load devices as supplied by
the user. For example, the module can control solenoids,
indicators, and motor starters. This module has no fuses but it
does have an LED block on top. This shows the status of the input
points (the top row – A1 to A8) and the output points (the bottom
row B1 to B8).
There is a door on the module. Users can use the door card for
recording information about circuit identification or circuit
wiring. This card has a red color code, which lets users know that
this is a high-voltage module. Like similar models, this one can be
installed in either a 5-slot or 10-slot baseplate to use it in a
Series 90-30 PLC system. Any I/O slot is compatible with the
IC693MAR590 Input/Relay Output module.
Inputs
Rated Voltage 120 volts AC
Input Voltage range 0 to 132 volts AC
Inputs per Module 8 (one group of eight inputs)
Isolation 1500 volts RMS between field and logic side
500 volts RMS between inputs
Input Current 12 mA (typical) at rated voltage
Input Characteristics
On-State Voltage 74 to 132 volts AC
Off-State Voltage 0 to 20 volts AC
On-State Current 6 mA (minimum)
Off-State Current 2.2 mA (maximum) 30 ms typical
On Response Time 30 ms typical
Off Response Time 45 ms typical
Outputs
Rated Voltage 24 VDC, 120/240 VAC
Operating Voltage 5 to 30 volts DC
5 to 250 volts AC, 50/60 Hz
Outputs per Module 8 (two groups of four outputs each)
Isolation 1500 volts RMS between field and logic side
500 volts between groups
Maximum Load + 2 amps maximum per output
4 amps maximum per common 10 mA
Minimum Load 10 mA
Maximum Inrush 5 amps
On Response Time 15 ms maximum
Off Response Time 15 ms maximum
Internal Power Consumption 80 mA (all I/O on) from +5V backplane bus
70 mA (all outputs on) from relay +24V backplane bus
